1. Qu’est-ce que IanniX ?
  2. Téléchargement
  3. Showcase
  4. Recherche
  5. À propos

Cursor speed

Accueil › Forums › Wanted! › Cursor speed

6 sujets de 1 à 6 (sur un total de 6)
  • Auteur
    Messages
  • 9 mai 2016 à 10 h 38 min #3753 Répondre
    Premislaus
    Invité

    Hi!

    I have next problem…

    So I have this case

    And I want to have 2 cursors starting from the same point with the SAME SPEED.
    Obviously, they have different road (circle is shorter) so they should split right away and circle should finish his cycle first.
    But I have problem setting it up in IanniX. There are 2 options – ‘Cursor length’ – which is not helpful, because I would have to count the road of both curves and ‘cursor speed’ which seems for me the good one. BUT – setting both of them on 1.0 (which for me is logic – ‘1’ should mean same speed) makes something weird. The circle cursor goes afterwards far more slowly than the other one…

    So… How make 2 cursors go with the same velocity?

    9 mai 2016 à 21 h 31 min #3754 Répondre
    IanniX
    Maître des clés

    Hi!

    Speed of « 1 » means 1 grid unit per second. If you type 2, it’ll be 2 grid unit per second.
    Because the shapes are different, the perimeter of the curves are different so you may want to set a fixed duration, which is the order field right next to the speed field in the inspector!

    11 mai 2016 à 20 h 08 min #3755 Répondre
    Premislaus
    Invité

    So I have to count the perimeter for both shapes and than set the time? I wanted to evade this one…:(

    11 mai 2016 à 22 h 51 min #3756 Répondre
    IanniX
    Maître des clés

    No no, just use the duration instead of the speed!

    13 mai 2016 à 20 h 14 min #3757 Répondre
    Premislaus
    Invité

    But I have to set duration for both of them in the way, that cursors would go with the same speed. That means, that durations of 2 curves are not equal. They vary because of different perimeters… So to count, using the simplest equation v=s/t I still have to know the « s ». Am I wrong?

    13 mai 2016 à 21 h 24 min #3758 Répondre
    IanniX
    Maître des clés

    In IanniX, you can enter the speed OR the duration. It means that if you want that the cursors finished their run on the 2 curves at the same time, you have to set the duration.
    If you want them to have the same speed, you have to set the speed.

  • Auteur
    Messages
6 sujets de 1 à 6 (sur un total de 6)
Répondre à : Cursor speed
Vos informations :




© IanniX Association

Qu'est-ce que IanniX ? | Téléchargement | Showcase | Forum | Recherche | À propos